|
ウエダ ヨシオ
Ueda Yoshio
上田 良夫 所属 追手門学院大学 理工学部 電気電子工学科 職種 教授 |
|
| 言語種別 | 英語 |
| 発行・発表の年月 | 2019/10/03 |
| 形態種別 | 論文 |
| 査読 | 査読あり |
| 標題 | A 6 MW/m2 High Heat Flux Testing Facility of Irradiated Materials Using Infrared Plasma-Arc Lamps |
| 執筆形態 | 共著・編著（代表編著を除く） |
| 掲載誌名 | Fusion Science and Technology |
| 掲載区分 | 国外 |
| 巻・号・頁 | 75(7),pp.690-701 |
| 国際共著 | 国際共著 |
| 著者・共著者 | Adrian S. Sabau,Kazutoshi Tokunaga,Michael G. Littleton,James O. Kiggans,Charles R. Schaich,Ralph B. Dinwiddie,Daniel T. Moore,Yoshio Ueda,Yutai Katoh |
| 概要 | A new line-focus reflector was designed and fabricated at Oak Ridge National Laboratory for a plasma-arc lamp (PAL) to attain a source heat flux of 12 MW/m2. The new reflector was fabricated with two ports for monitoring specimen condition during HHFT. At the same operational conditions for PAL, the absorbed heat flux in tungsten was increased from 1.39 MW/m2 with the uniform irradiance reflector to 5.12 MW/m2 for the line-focus reflector. This fourfold increase in the heat flux, at the same PAL electrode lifetimes, enabled cost-effective facility operation for a high number of cyclic high heat flux tests. Specifically, the test section is confined to a hemispherical dome, and specimens are bolted directly to a water-cooled copper alloy rod. Temperature measurement in the PAL facility was a main challenge due to a limited line of sight. |
| DOI | 10.1080/15361055.2019.1623571 |
| ISSN | 1536-1055/1943-7641 |